Laser Switch

[TimeSpaceLightForce]

The disc sensors of switches on 3 by 3 power grid
must be activated with enough beam energy passing
on above them. Using five mirrors and a Ray gun..

[ ] [ ] [ ] [ ] [ ] _/|== ---------

(o)-----------(o)-----------(o)------------(o)
-------------------------------------------------
-------------------------------------------------
(o)-----------(o)-----------(o)------------(o)
-------------------------------------------------
-------------------------------------------------
(o)-----------(o)-----------(o)------------(o)
-------------------------------------------------
-------------------------------------------------
(o)-----------(o)-----------(o)------------(o)

..find a way to toggle them all [on] with one shot.

[bonanova]

  Reveal hidden contents

This looks like a puzzle to touch a 4x4 array of dots

with 6 connected line segments.

a. Is that the idea?

b. Did you mean 4x4 and not 3x3?

[TimeSpaceLightForce]

  On 1/4/2013 at 7:07 AM, bonanova said:

  Reveal hidden contents

This looks like a puzzle to touch a 4x4 array of dots

with 6 connected line segments.

a. Is that the idea?

b. Did you mean 4x4 and not 3x3?

  Reveal hidden contents

a. i will check it out, was that submitted already? b. 1x1grid is a square same with 2 x 2 array

[bonanova]

  On 1/4/2013 at 8:12 AM, TimeSpaceLightForce said:

  Reveal hidden contents

a. i will check it out, was that submitted already? b. 1x1grid is a square same with 2 x 2 array

a. I'm asking whether that was the meaning. I don't think it has been previously posted.

[TimeSpaceLightForce]

  On 1/4/2013 at 8:22 AM, bonanova said:

  On 1/4/2013 at 8:12 AM, TimeSpaceLightForce said:

  Reveal hidden contents

a. i will check it out, was that submitted already? b. 1x1grid is a square same with 2 x 2 array

a. I'm asking whether that was the meaning. I don't think it has been previously posted.

Most of the connect-the-dot solutions i goggled are incompatible to this. For some are blocked by mirror or hit a switch twice..

..anyway since this is the oldest pending topic I posted

  Reveal hidden contents

[plasmid]

I would say that I only need four mirrors, as long as they're large enough.

  Reveal hidden contents

The beam enters through the upper left and leaves through the lower left, bouncing off the purple mirrors which are right next to the sensors on three sides and 1/2 of a square away on the other side. I get to hang the fifth mirror up on a wall at home.

[TimeSpaceLightForce]

  On 9/11/2013 at 12:17 PM, plasmid said:

I would say that I only need four mirrors, as long as they're large enough.

  Reveal hidden contents

lazer beam.jpg

The beam enters through the upper left and leaves through the lower left, bouncing off the purple mirrors which are right next to the sensors on three sides and 1/2 of a square away on the other side. I get to hang the fifth mirror up on a wall at home.

but then again hitting the switches twice toggles them off..