bonanova Posted July 20, 2015 Report Share Posted July 20, 2015 (edited) Using only a straight edge, construct a perpendicular to the drawn diameter of a circle, from a point P outside the circle. Edited July 25, 2015 by bonanova Reinserted image, which had disappeared from my media folder. Quote Link to comment Share on other sites More sharing options...
0 TimeSpaceLightForce Posted July 27, 2015 Report Share Posted July 27, 2015 (edited) starting with 3 points..connect P to diameter ends to make the points 4 & 5 on circumferenceconnect these points to opposite diameter ends to make intersection (point 6)..Draw an extended line from P thru 6 crossing diameter.. Edited July 27, 2015 by TimeSpaceLightForce redundant Quote Link to comment Share on other sites More sharing options...
0 bonanova Posted July 24, 2015 Author Report Share Posted July 24, 2015 Shamelessly bumping this thread. Quote Link to comment Share on other sites More sharing options...
0 Rainman Posted July 24, 2015 Report Share Posted July 24, 2015 What are the allowed operations? Can we only use the standard operations (connect two points or extend a line segment) or may we use other tricks, for example align the straightedge along the diameter and use the other side of the straightedge to draw a parallel line? Quote Link to comment Share on other sites More sharing options...
0 bonanova Posted July 25, 2015 Author Report Share Posted July 25, 2015 Standard. But I think the cat is out of the bag. Still getting used to the new posting protocol. Quote Link to comment Share on other sites More sharing options...
0 Franco Posted July 25, 2015 Report Share Posted July 25, 2015 If I got it right, we just need to construct a short line. Perpendicularity is out of the material contact. Quote Link to comment Share on other sites More sharing options...
0 bonanova Posted July 27, 2015 Author Report Share Posted July 27, 2015 To be more specific, you can draw a line segment between two existing points or extend an existing line segment.So I guess the OP should say you also have a pencil. That should do it.The straight edge has no markings - it's not a ruler; you can't twirl it like a compass ... etc. Quote Link to comment Share on other sites More sharing options...
0 bonanova Posted July 27, 2015 Author Report Share Posted July 27, 2015 TSLF has it. Nicely put into words. Quote Link to comment Share on other sites More sharing options...
Question
bonanova
Using only a straight edge, construct a perpendicular to the drawn diameter of a circle, from a point P outside the circle.
Edited by bonanovaReinserted image, which had disappeared from my media folder.
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.